Talk:Resistance wire

Electronics Low‑importance

	Electronics portal This article is part of WikiProject Electronics, an attempt to provide a standard approach to writing articles about electronics on Wikipedia. If you would like to participate, you can choose to edit the article attached to this page, or visit the project page, where you can join the project and see a list of open tasks. Leave messages at the project talk pageElectronicsWikipedia:WikiProject ElectronicsTemplate:WikiProject Electronicselectronic articles
Low	This article has been rated as Low-importance on the project's importance scale.

Materials Low‑importance

	This article is within the scope of WikiProject Materials, a collaborative effort to improve the coverage of Materials on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.MaterialsWikipedia:WikiProject MaterialsTemplate:WikiProject MaterialsMaterials articles
Low	This article has been rated as Low-importance on the importance scale.

Technology

This article is within the scope of WikiProject Technology, a collaborative effort to improve the coverage of technology on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.TechnologyWikipedia:WikiProject TechnologyTemplate:WikiProject TechnologyTechnology articles

Talk Page[edit]

OK then. (-: 207.63.251.215 19:03, 5 February 2007 (UTC)[reply]

Can this above rubbish go please?--DaveDodgy (talk) 15:57, 10 May 2008 (UTC)[reply]

Highest resistivity?[edit]

What's the highest resistivity resistance wire available? I know you can get wirewound resistors used for high voltage 'ballast' resistors in gas LASERs that are in the 100's of KΩ. So what are they made of? Or are they just normal resistance wire but ULTRA thin ?

When making a heating element, would a higher resistivity resistance wire be more efficient? And therefore drain a battery LESS, to provide the same amount of heat? --DaveDodgy (talk) 15:57, 10 May 2008 (UTC)[reply]

The Table[edit]

It should be removed. There is no source provided. Plus it is misleading since resistance will vary drastically with wire thickness (important data that is not included on the table). —Preceding unsigned comment added by 99.242.1.235 (talk) 23:41, 17 March 2009 (UTC)[reply]

Done (commented out). A working one with real units could be substituted or built on this. 91.154.87.201 (talk) 11:24, 10 January 2013 (UTC)[reply]

Carbon (amorphous) resistivity[edit]

Contradictory data for amorphous carbon resistivity. Text says: "The resistivity of amorphous carbon actually has a range of 3.8 - 4.1 × 10−6 Ω m." From the table, "Carbon (amorphous) 3.95 10−6 Ω-cm". Note the units: Ohm*m in one case, Ohm*cm in another. Both values seems to be wrong. Actual resistivity (see here for example) is about 35×10−6 Ω*m --Shcha (talk) 14:20, 6 January 2017 (UTC)[reply]