Talk:Hoist (mining)

A fact from Hoist (mining) appeared on Wikipedia's Main Page in the Did you know column on 5 November 2008, and was viewed approximately 2,518 times (disclaimer) (check views). The text of the entry was as follows:

Did you know... that a friction hoist can require up to 30 percent less motor power than a drum hoist for a given application?

A record of the entry may be seen at Wikipedia:Recent additions/2008/November.

Wikipedia

Mining Mid‑importance

	This article is within the scope of WikiProject Mining, a collaborative project to organize and improve articles related to mining and mineral industries. If you would like to participate, you can edit the attached article, or visit the project page, where you can see a list of open tasks, join in the discussion, or join the project.MiningWikipedia:WikiProject MiningTemplate:WikiProject MiningMining articles
Mid	This article has been rated as Mid-importance on the project's importance scale.

It is requested that a mechanical diagram or diagrams be included in this article to improve its quality. Specific illustrations, plots or diagrams can be requested at the Graphic Lab.
For more information, refer to discussion on this page and/or the listing at Wikipedia:Requested images.

Cross Reference[edit]

Hoist (device) contains material that probably belongs here. Hoist (the disambiguation page) needs a reference here. Then, we need to untangle the mining specific stuff from the general. Most of the characteristics of winding engines apply to all hoisting engines, whether in cranes, elevator shafts or mine hoists. Douglas W. Jones 128.255.45.57 (talk) 20:15, 24 November 2008 (UTC)[reply]

Diagram[edit]

We should add a diagram of a friction hoist as compared to a drum hoist to explain it. RJFJR (talk) 14:05, 5 November 2008 (UTC)[reply]

That is a good point...I will see if I can make one up--Kelapstick (talk) 14:36, 5 November 2008 (UTC)[reply]

Assessment comment[edit]

The comment(s) below were originally left at Talk:Hoist (mining)/Comments, and are posted here for posterity. Following several discussions in past years, these subpages are now deprecated. The comments may be irrelevant or outdated; if so, please feel free to remove this section.

Nothing to say how these hoists actually work, and why drum hoists are ok, but friction hoists notif shaft part flooded. If you are an engineer like myself you can work it out but.....

Last edited at 11:46, 5 November 2008 (UTC). Substituted at 18:08, 29 April 2016 (UTC)